Bulldog Security 721 Przewodnik Instalacji Pobierz pdf

CONTENTS

REMOTE STARTER MODELS RS92 / RS92E

INSTALLATION GUIDE

•

OWNER’S GUIDE

Technical Assistance

All tech personnel are expertly qualified to answer any technical questions.

Technicians are available Monday through Friday from 9:00 a.m. until 8:00 p.m. and Saturday 10:00 a.m. until 4:00 p.m.

Address

288 Canton Avenue • Wintersville, Ohio 43953

Telephone

Phone: 740-264-4710 • 800-878-8007 • Fax: 740-264-7306

System Features ....................................... 1

System Components ..................................... 1

Required Tools ........................................ 1

Technical Assistance .................................. 1

Before You Begin .................................... 1-2

Precautions........................................... 2

Testing Your Wires .................................... 2

Making Wiring Connections............................ 2-4

Locating & Making Connections........................ 4-5

Connecting the 12-Pin Harness and the 4-Relay Harness...6

Neutral Safety Switch ................................. 6

Antenna Placement (E Models)........................... 7

Anti-Theft System ..................................... 7

Factory Anti-Theft System.............................. 7

How to use Your Remote Transmitter ..................... 7

Programming Instructions .............................. 8

1 2 3 4 5 6 7 8 9

Podsumowanie treści

Strona 1 - OWNER’S GUIDE

CONTENTSREMOTE STARTER MODELS RS92 / RS92EINSTALLATION GUIDE•OWNER’S GUIDETechnical AssistanceAll tech personnel are expertly qualified to answer any

Strona 2 - REQUIRED TOOLS

SYSTEM FEATURESSYSTEM COMPONENTSTECHNICAL ASSISTANCEShould you need help. First check our website at www.bulldogsecurity.com/wires.htm or call our tol

Strona 3 - PRECAUTIONS

MAKING WIRING CONNECTIONS1. Strip back two inches of insulation on the wire from the keyless entry.2. Strip back one inch of insulation on the wire yo

Strona 4 - MAKING END TO END CONNECTIONS

4. Insert the wire from the unit through the hole as shown.6. Use electrical tape to wrap. Be sure to cover the wire about two inches on either side o

Strona 5 - Electrical Tape

ACCESSORY WIRE(S) THAT POWER THE HEATER/BLOWER MOTOR(+12V in run or on positions) This wire is also in the main ignition switch harness usually locate

Strona 6 - NEGATIVE PARKING LIGHT OUTPUT

5Note: Remove any paint belowthe spade connector.Factory BoltSpade ConnectorBlack Ground WireCHASSIS GROUNDLocate an easy to get to bolt or screwlocat

Strona 7 - NEUTRAL SAFETY SWITCH

6MECHANICAL NEUTRAL SAFETY SWITCH (Rear Wheel Drive Only)When installing a Bulldog remote starter on GM vehicles or Dodge Dakotas built prior to 1996,

Strona 8 - Antenna Tube

7FOR GENERAL MOTORS CARS ONLYSystem 1: PASSKEY I and II system (1985 and up). This system has a resistor pill in the key. Measureresistance of the pil

Strona 9 - PROGRAMMING INSTRUCTIONS

8PROGRAMMING INSTRUCTIONSENTERING PROGRAMMING MODEMake sure your vehicle is not running and the brake is pressed. The brake is to remain pressed aslon